Skip to Content

Changes for page Prusa Slicer

Last modified by Josh McGee on 2025/11/08 03:20
From version 8.1
edited by Josh McGee
on 2025/10/20 03:10
Change comment: There is no comment for this version
To version 7.2
edited by Josh McGee
on 2025/10/20 03:04
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -17,39 +17,5 @@
17 17  
18 18  === Select your print settings ===
19 19  
20 -1. (((
21 -Set the layer height using the Print Settings dropdown to be 0.2 by default.
22 -
23 -If you select smaller values then that will allow you to print finer details but the print will take longer.
24 -
25 -If you select larger values then your print will have less detail, but it will be faster.
26 -)))
27 -1. (((
28 -Set the filament type using the Filament dropdown. This should be written on the side of the filament reel.
29 -)))
30 -1. (((
31 -Set the printer type using the Printer dropdown. This should be written on a wooden card in front of the printer you're using.
32 -)))
33 -
34 -
35 -
36 -=== Orientation/Supports
37 - ===
38 -
39 -The orientation of your 3D print is important because each layer is supported by the one beneath it. For example if you were 3D printing a pyramid, you would ideally want the base of the pyramid to be the base of the 3d print. Use the Rotate command to rotate your part if you need to.
40 -\\??? image goes here: The rotate command can be found in the panel on the left
41 -
42 -
43 -If your design needs to have overhanging or unsupported pieces, then you have two main options:
44 -1) Have the slicer add in supports which can be broken off once the print is finished. To do this make sure the Supports dropdown is not None.
45 -2) Use the Cut command to cut your part into pieces that could each be printed like a pyramid. For example a sphere would be very difficult to print and would require a lot of supports, but if you cut the sphere in half each half could act effectively as a pyramid and would be very simple to cut. When the print is finished, the two halves can then be glued together.
46 -
47 -
48 -??? image goes here
49 -
50 50  ===
51 -\\Other printing options ===
52 -
53 -
54 -\\??? 2 images go here
55 -
21 +[[image:Screenshot 2025-10-20 140411.png||data-xwiki-image-style-alignment="center" height="325" width="500"]] ===