Changes for page Prusa Slicer

Summary

• Page properties (1 modified, 0 added, 0 removed)

Details

Page properties

Content

...	...	@@ -33,5 +33,23 @@
33	33
34	34
35	35
	36	+=== Orientation/Supports
	37	+ ===
36	36
	39	+The orientation of your 3D print is important because each layer is supported by the one beneath it. For example if you were 3D printing a pyramid, you would ideally want the base of the pyramid to be the base of the 3d print. Use the Rotate command to rotate your part if you need to.
	40	+\\??? image goes here: The rotate command can be found in the panel on the left
	41	+
	42	+
	43	+If your design needs to have overhanging or unsupported pieces, then you have two main options:
	44	+1) Have the slicer add in supports which can be broken off once the print is finished. To do this make sure the Supports dropdown is not None.
	45	+2) Use the Cut command to cut your part into pieces that could each be printed like a pyramid. For example a sphere would be very difficult to print and would require a lot of supports, but if you cut the sphere in half each half could act effectively as a pyramid and would be very simple to cut. When the print is finished, the two halves can then be glued together.
37	37
	47	+
	48	+??? image goes here
	49	+
	50	+===
	51	+\\Other printing options ===
	52	+
	53	+
	54	+\\??? 2 images go here
	55	+