Skip to Content

Changes for page Prusa Slicer

Last modified by Josh McGee on 2025/11/08 03:20
From version 3.1
edited by Josh McGee
on 2025/10/20 02:58
Change comment: Uploaded new attachment "Screenshot 2025-10-20 135757.png", version {1}
To version 8.1
edited by Josh McGee
on 2025/10/20 03:10
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -7,9 +7,49 @@
7 7  1. Add Creality Ender-3 with 0.6mm nozzle, Ender-5 with 0.4mm nozzle, and CR-5 Pro H with 0.4mm nozzle.
8 8  {{/expandable}}
9 9  
10 -== Load your file ==
10 +=== Load your file ===
11 11  
12 12  
13 13  If you have a .stl, .obj, .step, .amf, or .3mf file, use the 
14 14  File > Import > ImportSTL/3MF/STEP/OBJ/AMF command
15 +
16 +[[image:Screenshot 2025-10-20 135757.png||data-xwiki-image-style-alignment="center" height="290px" width="500px"]]
17 +
18 +=== Select your print settings ===
19 +
20 +1. (((
21 +Set the layer height using the Print Settings dropdown to be 0.2 by default.
22 +
23 +If you select smaller values then that will allow you to print finer details but the print will take longer.
24 +
25 +If you select larger values then your print will have less detail, but it will be faster.
26 +)))
27 +1. (((
28 +Set the filament type using the Filament dropdown. This should be written on the side of the filament reel.
29 +)))
30 +1. (((
31 +Set the printer type using the Printer dropdown. This should be written on a wooden card in front of the printer you're using.
32 +)))
33 +
34 +
35 +
36 +=== Orientation/Supports
37 + ===
38 +
39 +The orientation of your 3D print is important because each layer is supported by the one beneath it. For example if you were 3D printing a pyramid, you would ideally want the base of the pyramid to be the base of the 3d print. Use the Rotate command to rotate your part if you need to.
40 +\\??? image goes here: The rotate command can be found in the panel on the left
41 +
42 +
43 +If your design needs to have overhanging or unsupported pieces, then you have two main options:
44 +1) Have the slicer add in supports which can be broken off once the print is finished. To do this make sure the Supports dropdown is not None.
45 +2) Use the Cut command to cut your part into pieces that could each be printed like a pyramid. For example a sphere would be very difficult to print and would require a lot of supports, but if you cut the sphere in half each half could act effectively as a pyramid and would be very simple to cut. When the print is finished, the two halves can then be glued together.
15 15  
47 +
48 +??? image goes here
49 +
50 +===
51 +\\Other printing options ===
52 +
53 +
54 +\\??? 2 images go here
55 +
Screenshot 2025-10-20 140411.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.josh_mcgee_g
Size
... ... @@ -1,0 +1,1 @@
1 +68.1 KB
Content