Changes for page Prusa Slicer

Summary

• Page properties (1 modified, 0 added, 0 removed)
• Attachments (0 modified, 1 added, 0 removed)
  • image1.png

Details

Page properties

Content

...	...	@@ -40,9 +40,11 @@
40	40	=== ===
41	41
42	42	The orientation of your 3D print is important because each layer is supported by the one beneath it. For example if you were 3D printing a pyramid, you would ideally want the base of the pyramid to be the base of the 3d print. Use the (% class="mark" %)##Rotate##(%%) command to rotate your part if you need to.
43		-\\??? image goes here: The rotate command can be found in the panel on the left
	43	+\\
44	44
	45	+[[The rotate command can be found in the panel on the left>>image:image1.png||alt="The rotate command can be found in the panel on the left" data-xwiki-image-style-alignment="center" height="769px" width="500px"]]
45	45
	47	+
46	46	If your design needs to have overhanging or unsupported pieces, then you have two main options:
47	47	1) Have the slicer add in supports which can be broken off once the print is finished. To do this make sure the (% class="mark" %)##Supports##(%%) dropdown is not (% class="mark" %)##None##(%%).
48	48	2) Use the (% class="mark" %)##Cut##(%%) command to cut your part into pieces that could each be printed like a pyramid. For example a sphere would be very difficult to print and would require a lot of supports, but if you cut the sphere in half each half could act effectively as a pyramid and would be very simple to cut. When the print is finished, the two halves can then be glued together.

image1.png

Author

...	...	@@ -1,0 +1,1 @@
	1	+XWiki.josh_mcgee_g

Size

...	...	@@ -1,0 +1,1 @@
	1	+20.5 KB

Content