Skip to Content

Changes for page Prusa Slicer

Last modified by Josh McGee on 2025/11/08 03:20
From version 11.1
edited by Josh McGee
on 2025/10/20 03:20
Change comment: There is no comment for this version
To version 12.1
edited by Josh McGee
on 2025/10/20 03:22
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -37,13 +37,13 @@
37 37  
38 38  === ===
39 39  
40 -The orientation of your 3D print is important because each layer is supported by the one beneath it. For example if you were 3D printing a pyramid, you would ideally want the base of the pyramid to be the base of the 3d print. Use the Rotate command to rotate your part if you need to.
40 +The orientation of your 3D print is important because each layer is supported by the one beneath it. For example if you were 3D printing a pyramid, you would ideally want the base of the pyramid to be the base of the 3d print. Use the (% class="mark" %)##Rotate##(%%) command to rotate your part if you need to.
41 41  \\??? image goes here: The rotate command can be found in the panel on the left
42 42  
43 43  
44 44  If your design needs to have overhanging or unsupported pieces, then you have two main options:
45 -1) Have the slicer add in supports which can be broken off once the print is finished. To do this make sure the Supports dropdown is not None.
46 -2) Use the Cut command to cut your part into pieces that could each be printed like a pyramid. For example a sphere would be very difficult to print and would require a lot of supports, but if you cut the sphere in half each half could act effectively as a pyramid and would be very simple to cut. When the print is finished, the two halves can then be glued together.
45 +1) Have the slicer add in supports which can be broken off once the print is finished. To do this make sure the (% class="mark" %)##Supports##(%%) dropdown is not (% class="mark" %)##None##(%%).
46 +2) Use the (% class="mark" %)##Cut##(%%) command to cut your part into pieces that could each be printed like a pyramid. For example a sphere would be very difficult to print and would require a lot of supports, but if you cut the sphere in half each half could act effectively as a pyramid and would be very simple to cut. When the print is finished, the two halves can then be glued together.
47 47  
48 48  
49 49  ??? image goes here
... ... @@ -61,4 +61,4 @@
61 61  
62 62  Once you're happy with your settings, click the (% class="mark" %)##Slice now##(%%) button which can be found at the bottom of the right panel.
63 63  ??? image goes here
64 -Once it has finished slicing, the Slice now button will turn into Export G-code. Click this to save your g-code file.
64 +Once it has finished slicing, the (% class="mark" %)##Slice now##(%%) button will turn into (% class="mark" %)##Export G-code##(%%). Click this to save your g-code file.