Skip to Content

Changes for page Prusa Slicer

Last modified by Josh McGee on 2025/11/08 03:20
From version 10.1
edited by Josh McGee
on 2025/10/20 03:20
Change comment: There is no comment for this version
To version 11.1
edited by Josh McGee
on 2025/10/20 03:20
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -18,7 +18,7 @@
18 18  === Select your print settings ===
19 19  
20 20  1. (((
21 -Set the layer height using the Print Settings dropdown to be 0.2 by default.
21 +Set the layer height using the (% class="mark" %)##Print Settings##(%%) dropdown to be (% class="mark" %)##0.2##(%%) by default.
22 22  
23 23  If you select smaller values then that will allow you to print finer details but the print will take longer.
24 24  
... ... @@ -25,10 +25,10 @@
25 25  If you select larger values then your print will have less detail, but it will be faster.
26 26  )))
27 27  1. (((
28 -Set the filament type using the Filament dropdown. This should be written on the side of the filament reel.
28 +Set the filament type using the (% class="mark" %)##Filament##(%%) dropdown. This should be written on the side of the filament reel.
29 29  )))
30 30  1. (((
31 -Set the printer type using the Printer dropdown. This should be written on a wooden card in front of the printer you're using.
31 +Set the printer type using the (% class="mark" %)##Printer##(%%) dropdown. This should be written on a wooden card in front of the printer you're using.
32 32  )))
33 33  
34 34