Skip to Content
Last modified by Darren Cocco on 2026/01/13 11:36
From version 2.1
edited by Josh McGee
on 2025/11/12 00:28
Change comment: There is no comment for this version
To version 3.1
edited by Josh McGee
on 2025/11/12 00:29
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -2,4 +2,37 @@
2 2  
3 3  = **Printing** =
4 4  
5 ---- TBD ---
5 +== Setup ==
6 +
7 +If the screen on the front is dark, the printer is probably off. The on/off button is at the back on the right.
8 +
9 +
10 +??? image goes here
11 +
12 +== Navigation ==
13 +
14 +The knob on the front of the machine is used for navigating the printer settings. Turn the knob to toggle through menu items. Press the knob to submit the menu item, and to back out there is often a "Main" item that will take you back.
15 +
16 +??? image goes here
17 +
18 +== Loading filament ==
19 +
20 +1. Unload old filament first using [[this section of the guide>>doc:Workflows.3D Printing.Preparing To Print.WebHome]].
21 +1. Navigate to the (% class="mark" %)##Load filament##(%%) option ??? add image here
22 +1. Select your material type from the list. It will then heat to the temperature associated with that material. ??? add two images here
23 +1. When it prompts you, load the filament into the nozzle and press the knob. ??? add two images here
24 +1. Some of the old colour may be remaining in the system so continually press the knob until it extrudes with the correct colour. ??? add image here
25 +
26 +
27 +== Insert SD card ==
28 +
29 +The SD card goes into the hole to the left of the screen, as pictured.
30 +??? add image here
31 +
32 +== Printing ==
33 +
34 +1. Once your SD card is in the printer, select the (% class="mark" %)##Print from SD##(%%) option, and navigate through the SD card file system to your file ??? add image here
35 +1. The bed will heat to the target temperature. This is done so that the first layer of extruded material is able to stick to it more easily. ??? add image here
36 +1. After heating the bed, it will perform a bed levelling procedure. This may leave small marks on the print bed that should be removed so they don't get in the way of the print. ??? add image here
37 +1. After the bed levelling procedure, it will start to print. It's worth standing by and watching the first layer or two of the print, because if something is going to go wrong in the print it is most likely to go wrong in the first couple of layers.
38 +