Skip to Content

Changes for page Preparing To Print

Last modified by Darren Cocco on 2026/01/13 04:58
From version 6.1
edited by Josh McGee
on 2025/11/08 03:22
Change comment: There is no comment for this version
To version 3.1
edited by Josh McGee
on 2025/11/08 02:07
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,11 +1,12 @@
1 -=== **Prepare SD Card** ===
1 +=== Prepare SD Card ===
2 2  
3 3  Put your (% class="mark" %)##.gcode##(%%) file on an SD card. If you have a MicroSD card slot available but don't have a SD card slot, there are SD card to MicroSD card adapters available at MCI.
4 -\\\\??? insert cropped image here: The smaller MicroSD card fits in side of the slot of the SD card adapter.
4 +\\??? Image goes here: The smaller MicroSD card fits in side of the slot of the SD card adapter.
5 +
5 5  
6 -=== **Prepare filament** ===
7 +=== Prepare filament ===
7 7  
8 -==== **Removing existing filament** ====
9 +==== Removing existing filament ====
9 9  
10 10  When removing filament from the machine, put it in a vacuum sealed plastic bag with two blue desiccant bags so that it stays dry. The bags have a pattern on them that allows air to flow even if the two sides of the plastic are in contact.
11 11  
... ... @@ -21,10 +21,10 @@
21 21  
22 22  ??? image goes here
23 23  
24 -==== **Selecting filament** ====
25 +==== Selecting filament ====
25 25  
26 26  
27 -Specific instructions about how to install the filament are provided later in the [[3D Printing>>doc:Areas.Upstairs.3D Printing.WebHome]] section
28 +Specific instructions about how to install the filament are provided later in the [[3D Printing>>doc:Workflows.3D Printing.3D Printing.WebHome]] section
28 28  
29 29  Ensure you have enough filament for print. 
30 30  Ensure no tangles on filament.
image28.png
Author
... ... @@ -1,1 +1,0 @@
1 -XWiki.josh_mcgee_g
Size
... ... @@ -1,1 +1,0 @@
1 -1.0 MB
Content