Skip to Content

Changes for page Preparing To Print

Last modified by Darren Cocco on 2026/01/13 04:58
From version 3.2
edited by Josh McGee
on 2025/11/08 02:09
Change comment: Renamed back-links.
To version 9.1
edited by Josh McGee
on 2025/11/19 09:41
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,12 +1,11 @@
1 -=== Prepare SD Card ===
1 +=== **Prepare SD Card** ===
2 2  
3 3  Put your (% class="mark" %)##.gcode##(%%) file on an SD card. If you have a MicroSD card slot available but don't have a SD card slot, there are SD card to MicroSD card adapters available at MCI.
4 -\\??? Image goes here: The smaller MicroSD card fits in side of the slot of the SD card adapter.
5 -
4 +\\[[image:image28.png||data-xwiki-image-style-alignment="center" height="500px" width="467px"]]
6 6  
7 -=== Prepare filament ===
6 +=== **Prepare filament** ===
8 8  
9 -==== Removing existing filament ====
8 +==== **Removing existing filament** ====
10 10  
11 11  When removing filament from the machine, put it in a vacuum sealed plastic bag with two blue desiccant bags so that it stays dry. The bags have a pattern on them that allows air to flow even if the two sides of the plastic are in contact.
12 12  
... ... @@ -13,7 +13,7 @@
13 13  When the desiccant balls have turned purple they will be less effective at absorbing moisture and should be thrown out. When the bags are no longer able to hold a vacuum within them, they should be thrown out.
14 14  
15 15  
16 -??? image goes here
15 +[[image:image5.png||data-xwiki-image-style-alignment="center" height="327px" width="500px"]]
17 17  
18 18  Never release the loose end of a removed spool of filament. If the filament gets tangled, it can become impossible to untangle the spool, requiring it to be discarded.
19 19  
... ... @@ -20,9 +20,9 @@
20 20  The spools have filament retention holes around their edges. Use them to secure the loose end.
21 21  
22 22  
23 -??? image goes here
22 +[[image:image38.png||data-xwiki-image-style-alignment="center" height="331px" width="500px"]]
24 24  
25 -==== Selecting filament ====
24 +==== **Selecting filament** ====
26 26  
27 27  
28 28  Specific instructions about how to install the filament are provided later in the [[3D Printing>>doc:Areas.Upstairs.3D Printing.WebHome]] section
image28.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.josh_mcgee_g
Size
... ... @@ -1,0 +1,1 @@
1 +1.0 MB
Content
image38.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.josh_mcgee_g
Size
... ... @@ -1,0 +1,1 @@
1 +182.2 KB
Content
image5.png
Author
... ... @@ -1,0 +1,1 @@
1 +XWiki.josh_mcgee_g
Size
... ... @@ -1,0 +1,1 @@
1 +197.4 KB
Content