Skip to Content

Changes for page Preparing To Print

Last modified by Darren Cocco on 2026/01/13 04:58
From version 3.2
edited by Josh McGee
on 2025/11/08 02:09
Change comment: Renamed back-links.
To version 5.1
edited by Josh McGee
on 2025/11/08 02:35
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -1,12 +1,12 @@
1 -=== Prepare SD Card ===
1 +=== **Prepare SD Card** ===
2 2  
3 3  Put your (% class="mark" %)##.gcode##(%%) file on an SD card. If you have a MicroSD card slot available but don't have a SD card slot, there are SD card to MicroSD card adapters available at MCI.
4 4  \\??? Image goes here: The smaller MicroSD card fits in side of the slot of the SD card adapter.
5 5  
6 6  
7 -=== Prepare filament ===
7 +=== **Prepare filament** ===
8 8  
9 -==== Removing existing filament ====
9 +==== **Removing existing filament** ====
10 10  
11 11  When removing filament from the machine, put it in a vacuum sealed plastic bag with two blue desiccant bags so that it stays dry. The bags have a pattern on them that allows air to flow even if the two sides of the plastic are in contact.
12 12  
... ... @@ -22,7 +22,7 @@
22 22  
23 23  ??? image goes here
24 24  
25 -==== Selecting filament ====
25 +==== **Selecting filament** ====
26 26  
27 27  
28 28  Specific instructions about how to install the filament are provided later in the [[3D Printing>>doc:Areas.Upstairs.3D Printing.WebHome]] section